Why does my HDD go to standby mode later than the time I set?
Posted by Alan Huang on 03 January 2012 01:56 PM

The hard drive(s) on QNAP NAS may seem to go to standby mode a bit later than the time you specified when data writing is in process. In fact, this is related to the data writing behaviour of the embedded Linux system. When you save data to the NAS, the data is written to the system cache first and then to the hard drive(s) on the NAS. The write time depends on the size of the data. After the data is written and there is no access to the hard drive, the hard drive(s) go to standby mode according to your settings in System Tools/ Hardware Settings on the administration page.


Applied Models: All NAS series

(0 vote(s))
Not helpful

Comments (0)