Knowledgebase
Why does my quick installation page show nothing? (See attached image)
Posted by Daniel Orme on 23 December 2011 02:24 PM

Please follow the procedure below to solve this problem.

  1. Power off the NAS.
  2. Remove all HDDs.
  3. Power on.
  4. System will make 1 short beep when you power on, and then after 2~4mins will make a 2nd long beep.
  5. After the 2nd long beep, please plug in the HDD in sequence, ex: HDD1 --> slot 1, HDD2 --> slot2....etc.
  6. Please run the QNAP Finder and double click on the NAS unit.
  7. Keep following the quick installation setup.

 

Applied Models: All NAS Series



Attachments 
 
(16 vote(s))
Helpful
Not helpful

Comments (0)