Knowledgebase
[SMB Firmware] How to change the status LED by command line
Posted by Daniel Orme on 12 February 2014 02:59 PM

The command is:

 

hal_app --se_sys_set_status_led enc_sys_id=root,status_led=XXX,enable=YYY

 

XXX = red or green
YYY = 0 (turn off) or 1 (turn on)

 

Example:

 

if you want to turn off the red status led
hal_app --se_sys_set_status_led enc_sys_id=root,status_led=red,enable=0

 

If you want to turn on the green status led

hal_app --se_sys_set_status_led enc_sys_id=root,status_led=green,enable=1

 

 

This only applies to SMB firmware.

(2 vote(s))
Helpful
Not helpful

Comments (0)