Knowledgebase
My NAS hard drives are full and can't access the data to delete anything.
Posted by Daniel Orme on 06 November 2013 10:09 AM

What to do if the NAS drives become full and can't access the data:

Applicable models:

TS-x10 series

TS-110, TS-210, TS-410, TS-410U

TS-x12 series

TS-112, TS-112P, TS-212, TS-212P, TS-212-E, TS-412

TS-x19 series

TS-119, TS-119P+, TS-119P II
TS-219, TS-219P, TS-219P+, TS-219P II
TS-419P, TS-419P+, TS-419P II, TS-419U, TS-419U+, TS-419U II

TS-x20 series

TS-120, TS-220, TS-420, TS-420U

TS-x21 series

TS-121, TS-221, TS-421, TS-421U

TS-x39 series

TS-239 Pro, TS-239 Pro II, TS-239 Pro II+, TS-239H
TS-439 Pro, TS-439 Pro II, TS-439 Pro II+, TS-439U
TS-639 Pro, SS-839 Pro

TS-x59 series

TS-259 Pro, TS-259 Pro+
TS-459 Pro, TS-459 Pro+, TS-459 Pro II
TS-559 Pro, TS-559 Pro+, TS-559 Pro II
TS-659 Pro, TS-659 Pro+, TS-659 Pro II
TS-859 Pro, TS-859 Pro+, TS-859U-RP, TS-859U-RP+

TS-x09 series

TS-509 Pro, TS-809 Pro, TS-809U

  1. Power off the NAS and remove all HDDs

  2. Boot the NAS up without any drives inside

  3. After the second long beep is heard, the NAS should be found by QNAP Finder

  4. Download and run PuTTY (www.chiark.greenend.org.uk/~sgtatham/putty/download.html)

  5. Enter the NAS IP to connect and login with the user and password “admin”

  6. Hot-plug all the HDDs back into the NAS (leave the NAS powered up)

  7. Run the commands below via the PuTTY console:

    • config_util 1

    • storage_boot_init 1

    • storage_boot_init 2

    • cd /share/MD0_DATA
      (for single disk volume use /share/HDA_DATA)

  1. You should now be inside your RAID data volume. Use the commands below to navigate to and delete some unwanted files (a few 100Mb should be sufficient)

    • ll - list the contents of a directory

    • cd directory_name - move into the directory directory_name

    • rm filename - delete the file filename

NOTE: if you are unsure at any point please contact QNAP support to perform the procedure. The rm command will delete files permanently so be careful when using it!


  1. After you have deleted unwanted files, reboot the NAS by typing reboot


  1. The NAS should be accessible as usual after reboot. Please update to the latest firmware to prevent the hard-drive full bug from re-occurring.

 

(64 vote(s))
Helpful
Not helpful

Comments (0)