Knowledgebase
I have installed two power supply units on the NAS (available on some rack mount models). Why was no error message shown when I plugged out one of the power supply units?
Posted by Daniel Orme on 03 January 2012 02:54 PM

Please check if the redundant power supply mode is enabled on “System Administration” > “Hardware”. When this function is enabled, the NAS will start to record the error messages about the power supply units on “System Logs”.

 

Applied Models: TS-xx9U-RP NAS Models

(1 vote(s))
Helpful
Not helpful

Comments (0)